Separator and Coalescer filters are designed for the specific use of separation and removal of water form gasoline, aviation fuel, kerosene, and diesel fuel. They are normally constructed from a combo of pleated and wrapped layers of fiberglass media. Top quality Separator and Coalescer filters are capable of great flow rates and taking out of liqud down to 5ppm. The application differs, but great quality filter efficiencies get from .5 to .25 micron.
The separator filter is known as an accomplice to the coalescer. Separators are generally offered in the formats of Teflon coated, silicone treated cellulose, and fully synthetic. Separator and coalescer filters are available to adhere to commercial, military, and API needs.
Coalescer filters are multi-stage separator filters that give great liquid and solid removal. The 1st stage allows for the removal of great particulates and fluid loads through centrifugal and gravitational forces. If an extremely large solid or liquid load is at hand, other separation internals are available to give great removal and give additional life to the coalescer filter.
The ultimate stage of separation happens when one or more multi-special layered coalescer filters has gas flow freely from the inner layer to the outside of the Coalescer filters. The deepest interior layer works as a pre-filter to remove submicron solids.
The fibers of the middle layer grip of the liquid droplets help in the gas emissions and result in droplets moving together to form bigger droplets within the depth of the filter. The large drops appear on the outside surface of the coalescer and drain by science of gravity into the lowest collection center. The gasses pass from the separator filters outside through the vessel outlet.
Filters can sometimes be difficult to understand as they have some hard to understand terminology and hard to understand processes, however, they are great, especially in the case of Coalescer and Separator Filters.
Stainless Steel Filter,
Blower Filter,
Coalescer Filter
