There is another method that employs the American sound isolation tape and that is to double layer it on every other stud. If your studs are 16 OC then you will be taping every other stud at 32” OC. Once you have double taped every other stud, you will screw your drywall only into the taped studs. This will not only give you the isolation of the wood or steel structure from the outer wallboard, but it will give you the same effect as staggered studs. This method can be employed on both sides of the studs and to the end facings of joists. You can even tape the joists above before installing a sub floor, which will help to isolate the sub floor from the joists and the ceiling below. If you are in the process of new construction or remodeling where you have removed all drywall, taping the studs and joists with the American Isolation tape is essential. If you are remodeling or under new construction, American Sound Isolation tape is an effective and economical way to give your drywall the isolation it needs from the wood structure. This isolation will help to give you some good soundproofing between bedroom walls for example and doesn’t cost you an arm and a leg to install. There are many other uses for American Sound Isolation tape that I just couldn’t fit into this article. Builders and contractors across the United States and Canada are now using American sound isolation tape as a low cost soundproofing alternative to the more costly foams and barriers.
For more information on American sound isolation tape or other quality soundproofing products go to my blog at: http://massloadedvinyl.blogspot.com/ Thanks for reading and learning about American Sound Isolation tape. This is Dr. Bob...Out!!!
This article is free for republishing
Source: http://www.articlealley.com/article_253845_27.html
Source: http://www.articlealley.com/article_253845_27.html

