To help you prepare for Cisco certification exam success, here are some complimentary Cisco practice exam questions. Answers can be found at the end of the article. Enjoy, and no peeking!
CCNA Certification:
In the following show cdp output, which values have been changed from their default, if any?
Router1#show cdp
Global CDP information:
Sending CDP packets every 60 seconds
Sending a holdtime value of 180 seconds
Sending CDPv2 advertisements is enabled
CCENT Certification:
Examine the following ip route command and identify the true statements.
R1(config)#ip route 30.0.0.0 255.0.0.0 ethernet1
A. The network route shown is invalid.
B. The network mask shown should be in wildcard mask form (0.0.0.255)
C. The ethernet1 interface indicated is on the local router.
D. The ethernet1 interface indicated is on the next-hop router.
E. This is a default static route.
CCNA Security Certification / CCNP ISCW Exam:
What are the two options you should expect to see IOS Help display in the following command?
R1(config)#ip tcp intercept mode ?
CCNP Certification / BSCI Exam:
Identify the correct statements regarding the EIGRP topology table.
A. There can be multiple successors.
B. There can be multiple feasible successors.
C. There can be only one successor.
D. There can be only one feasible successor.
E. There are no successors in this table.
F. There are no feasible successors in this table.
CCNP Certification / BCMSN Exam:
What command will allow a port to carry only traffic for VLANs 1, 100, and 200?
CCNP / ONT Exam:
Identify the true statements regarding traffic policing.
A. Can drop out-of-profile packets or re-mark the traffic with a new value
B. All out-of-profile packets are dropped
C. Only incoming traffic can be policed
D. Only outgoing traffic can be policed
E. Both incoming and outgoing traffic can be policed
Here are the answers!
CCNA: None of the CDP defaults have been changed. The Cisco Discovery Protocol is enabled both globally and on all interfaces by default, but for security reasons this default is often changed. You should know how to do so on both a global and per-interface basis for your CCNA exam, too!
CCENT: C. The ip route command shown is valid, and the mask is shown in correct form. The specified interface is the local exit interface. This is not a default static route - such an ip route statement would have all zeroes for the network and the mask.
CCNA Security / ISCW Exam: You can run TCP interfcept in intercept or passive mode.
CCNP / BSCI Exam: A, D. You can have multiple successor and feasible successor routes in the EIGRP topology table.
CCNP / BCMSN Exam: Use the following configuration to carry this task out. You don't have to specify VLAN 1, since you can't delete or block traffic on that specific VLAN to begin with.
interface FastEthernet0/12
switchport trunk allowed vlan 100,200
CCNP / ONT Exam: A, E. With traffic policing, you have the option of dropping packets or re-marking them. You can also police traffic as it enters or exits the router.
Look for more Cisco certification exam training questions and fully illustrated tutorials on my website, as well as the one you’re on right now!
