Do You Know How to Remove Mold Stains From Your Hardwood Floors?
By: Christopher Smith | Posted: 26th June 2007
You can consider it a blessing if you have hardwood floors in your home; many people only wish they had them. Not only are these floors lovely, they are particularly practical as well. Wood floors are known to last for many years when they are properly maintained and cared for, and they stand up well in all types of weather conditions. Despite this, even those who are very particular not to allow water on the wooden flooring have been known to occasionally develop a mold problem.
Flowerpots are the primary culprit when it comes to exposing your wood to unattended moisture issues that often lead to mold and/or mildew on your hardwood floors. Even the smallest of leaks if not properly and immediately cared for can cause big problems when it comes to your hardwood floors. Most of the time the damage beneath the pot is fairly extensive by the time you realize the damage has been done.
The good news (if you can believe there is good news in a situation like this) is that this is not damage that is permanent. With a little work and the proper information this problem can be repaired. In most cases, if your floor is finished, the mold can be removed and you will find that only the finish of your floor is actually damaged.
Your first step is to find a scraper (these can be found at local hardware stores, often in the paint supply department). While size isn't the most important feature of this scraper, 8 inches wide is a good start. Pull the scraper along the grain of the wood and adjust your pressure so that the edge of the scraper is in contact with the finish of your floor. Be careful that you do not dig too deep with this tool or your will run the risk of damaging your floors.
The next thing you will need is a sanding sponge (180 grit) that is designed for the purpose of finish removal. You should then sand along the grain until you have removed most if not all of the mold. If there happens to be a little mold remaining you can use a diluted mixture of Clorox on the area to finish the job. You should be careful though as this could harm the floor if proper caution is not taken.
Once you've finished sanding and bleaching, sand again--this time with 200 grit sand paper. Then you should touch up the finish with the same finish, if possible, that was used on the remainder of the floor, if you can't find an exact match you should go with the closest possible match.
To prevent this type of problem, be sure that all your potted plants have proper drainage and that there are no pots leaking onto your flooring. In fact, all liquid spills should be quickly and properly cleaned up as they occur. These small steps will safeguard and prolong the magnificence and lifetime of your beautiful hardwood flooring.
Visit us for more information on how to clean hardwood floors, refinishing hardwood and how to clean bamboo floors.
This article is free for republishing
Printed From: http://www.articlealley.com/article_177290_27.html
Back to the original article
Tags: job, risk, culprit, hardware stores, mixture, leaks, hardwood floors, weather conditions, pot, mold problem, clorox, mildew, grit, flowerpots, wood floors, scraper, wooden flooring