Using GPS for NTP and Time Server Systems
By: Dave | Posted: 31st January 2008
GPS is a US military system that provides highly precise time and positioning information anywhere around the globe. The system consists of 24 Earth orbiting satellites each constants broadcasting accurate time and positioning information to Earth. The broadcast is a weak radio signal that can be received by low-cost equipment and used for positioning and highly precise time and frequency applications.
This article describes how the GPS system can be used to provide an accurate time and frequency reference for NTP servers and computer network time synchronisation.
GPS timing information is continuously broadcast by each GPS satellite. GPS time is not affected by leap seconds. GPS time is currently exacly fourteen seconds ahead of Universal Coordinated Time (UTC). However, offset information is available to readily convert GPS time to UTC time, which is used in NTP server and computer time server systems.
Each GPS satellite transmits information as very low-power radio frequency transmission. Two frequencies are used, one for civilian use coded L1, and one for military use coded L2. The civilian L1 frequency is the most widely used and is transmitted at 1575 MHz. The broadcast GPS signal can easily penetrate less dense material such as plastic, but cannot penetrate higher density materials such as brick.
An antenna is utilised to boost the GPS signal and pass the signal along a coax cable. Ideally, a GPS antenna needs to have as good a view of the sky as possible to receive from as many satellites as possible. Ideally, it should be located outdoors on a rooftop with a good 360-degree un-obscured view of the sky.
GPS antenna systems transmit signals down a coax cable and are sensitive to coax quality and cable length. The coax type and antenna gain determines the cable length that can be utilised by a GPS antenna. Higher quality coax cable generally have much lower attenuation figures and hence provide much longer cable runs between the receiver and antenna. Typically, a low-quality coax can run to 20-30m, while a high quality coax can be used in excess of 100m cable runs. For extended cable runs, a GPS amplifier can be placed in-line on the coax cable to amplify the weak GPS signals.
GPS timing systems also utilise a GPS receiver in order to decode the received GPS transmission and convert it to a computer readable format. The GPS receiver processes the transmitted GPS positioning information and provides a readable serial transmission as output. GPS NTP servers and computer time servers may also utilise a precise pulse per second output generated by the GPS receiver to provide ultra-precise timing. The pulse per second timing pulse on most receivers is accurate to within a few milliseconds of UTC.
The Global Positioning System (GPS) is ideally suited to providing NTP time servers with a highly accurate external timing reference for synchronisation. Accuracies of a few hundred nanoseconds can be reasonably achieved with low-cost GPS receiving equipment.
------
D. Evans has written many technical articles on the subject of computer time synchronisation and NTP server systems. Click here, for more detailed information about NTP time server systems.
This article is free for republishing
Printed From: http://www.articlealley.com/article_464785_45.html
Back to the original article
Tags: accurate time, precise time, orbiting satellites, gps antenna, time synchronisation, ntp servers